CUTIM Ultra-Bright LED Logo Projection Puddle Lights for Tesla Model 3/Y/S/X

Why Choose Projection Puddle Lights?

Standard factory puddle lights provide basic illumination, but they lack the premium flair that defines a Tesla. These high-definition projection lights replace your stock door lamps to cast a crisp, vibrant Tesla logo onto the ground every time you open the door. The projection is a decorative lighting feature, not a guarantee of safe footing or visibility.

Product Features

• High-Definition Clarity: Equipped with premium laser-etched quartz glass lenses (not cheap film), ensuring the projected image remains sharp, bright, and fade-free over years of use.

• Ultra-Bright LED Output: Delivers significantly higher lumens than factory lights, Actual light output and coverage require item-specific testing.

• OEM-Style Plug & Play: Designed as a direct replacement for the original lamps. Verify the exact door housing, connector, voltage range, and vehicle generation before installation.

• Intelligent Heat Management: Features an aluminum heat sink back cover to dissipate heat efficiently, Thermal performance and compatibility with door electronics have not been verified.

• Weatherproof Design: Fully sealed housing prevents moisture and dust from entering the lamp, ensuring consistent performance in rain or snow.

Specifications

• Material: ABS Housing + Aluminum Heat Sink + Quartz Glass Lens

• Voltage: Rated input and compatibility with the vehicle low-voltage system require verification.

• Color Temperature: 6000K–6500K (Crystal White)

• Installation Time: Follow item-specific instructions after electrical and door-system compatibility has been verified.

• Lifespan: Over 50,000 hours of operation

Compatibility

Precision fit for the door panels across the Tesla lineup:

• Tesla Model 3 / Highland (2017 – Present)

• Tesla Model Y / Juniper (2020 – Present)

• Tesla Model S / Plaid (2012 – Present)

• Tesla Model X (2015 – Present)

How To Install

1. Safety First: Fully lower the window of the door you are working on to prevent potential glass interference if the door logic resets.

2. Pry: Use a plastic trim tool to gently pop the existing light out from the bottom of the door panel.

3. Unplug: Press the release tab on the wiring connector and remove the factory light.

4. Connect: Plug the new projection light into the connector. Verify the logo orientation before snapping it back into the door.

5. Test: Close and open the door to ensure the light activates instantly and the image is perfectly centered.

Disclaimer All references to other companies or trademarks are for identification only. CUTIM is not affiliated with or endorsed by Tesla Inc.